Textile Finishing AgentsTextile Finishing Agent
Silicon dioxideSiO2 Nanoparticle /Nanopowder CAS Number : 7631-86-9
Textile Protect WBPro™ is a highly-flexible, transparent, breathing, water-based impregnation with built-in protection against marks and stains.Its anti-adhesive components give treated textiles a breathing surface that allows water vapour to pass through while at the same time preventing the passage of water or the adhesion of oil, dirt and dust. Easy to apply, it contains no waxes or silicones and can be washed up to 10 times before retreatment is necessary. Other properties: 1. Washable up to 10 times 2. Invisible 3. Will not discolour or “yellow” 4. Strong impregnation effect 5. Increases the lifetime of treated surfaces 6. Allows treated items to be cleaned with plain water 7. Treated items can be washed up to 10 times and then simply re-treated.
Coverage: Depending entirely upon the surface to be treated and the method used, about 10 m² can be treated with one liter of this product. Availability: Always test a small sample to ensure that the desired result is achieved before proceeding with the main project. If in doubt, do not proceed. Do not dilute. The surface to be treated must be dry, free of dust and dirt with no oil or fats. Work and apply at temperatures above 5°C. Previously applied impregnations or treatments can influence the result. The surface must be acceptable to this product. Apply by spraying evenly from a distance of about 20 cm, and allow drying for approximately 1 hour. After 24hours the full effectiveness of this product is realised. A repeated application or an “ironing-in” (at 80 to 120 °C.) will increase the quality of the result. Alternatively treated textiles can be heat-treated using a (domestic) clothes drier. When the effect has eventually worn down – quite simply refresh, using the treatment method described here. Alternatively you can try to heat again. The suitability and the colour-fastness of the material to be treated should be tested prior to final application of the product. Application specifics depend very much upon the surface of the material to be treated, and we will be pleased to give you comprehensive details on this subject. Depending entirely upon the surface to be treated and the method used, about 10 m² can be treated with one liter of this product. 0,5 litre pump-spray-bottle, 1 litre bottle, 5 litre canister, 10 litre canister. Other packing forms/sizes are possible after prior consultation with us and according to the transport possibilities/regulations.